Anyone who can answer this question for me is getting a free Nerf-brand Tactical Vest from ME. I'm still trying to find a priming solution for my Longstrike with the OMW Stage 1 Kit in it. The blaster shoots REALLY far, but the priming handle keeps popping off because the bolt sled on the inside of the blaster is too weak and is warping as I prime it.
Would a Massacre polycarbonate bolt sled in that kit solve this issue? Or do I have to wait for the Stage 2 kit for the Longstrike to get the better bolt sled?
I'd love to help but I really didn't pay much attention to the internals of my longstrike before I started ripping them out. If you could post some more pictures that'd be great.
ReplyDeleteLol! Remember the 'pizza Mod kit' ? That was helarious.
ReplyDeletecombining a stiffer bolt sled with a spare longshot priming handle might work, but I'm not really sure to be honest. longshot handles seem to be a bit better than the longstrike ones in my limited experiences of lonstrikes.
ReplyDeleteMan I am liking this blog more and more since I began following last week. Well anyway I do have one suggestion assuming that the bolt-sled did not break: I would try reinforcing the area where the bolt pulls the bolt-sled back, with epoxy putty to prevent it from warping. Hope that helps.
ReplyDeleteThe massacre kit is replacing the stage 2 kits, they said that if you already had stage one you could buy just the bolt-sled and plunger. If the bolt-sled is your problem then this should fix it.
ReplyDeleteYou need to reinforce the boltsled with aluminum followed by superglueing the actual priming bar closed again as they are weakened from the inital opening, youll still be able to get it open if you ever desire to, but it'll be tougher for obvious reasons.
ReplyDeleteYes, the Massacre kit would solve that because it has a stronger bolt sled. Still, you should do what Drac said and reinforce the blod sled.-Awesomeness
ReplyDelete